Error message E92 only occurs with the PureSpa with chlorine generator. This error message does not indicate a defect in the control box but a too high salt content in the water. If too much salt has been added to the water, the system will give a beep signal and the error message E92 appears on the display.


Step 1:

Switch off the control box by pressing the ON / OFF button

Unplug the power cord.

Step 2:

Drain around 25% of the water in the tub

Step 3:

Plug in the power cord.

Switch the system back on by pressing the ON / OFF button.

Step 4:

Refill the tub with tap water.

Refresh until error message E92 disappears from the display.

Error message E92 has not disappeared

Register the problem online at the Intex Service center: After receiving the registration, the service will propose a suitable solution. "